The magnetic chuck is suitable for holding widia (HM) tools, used for woodworking during re-grinding operations. It is especially suited for linear or surface grinders because the supporting bed is parallel with the magnetic surface. The chuck has a strong holding power because the tools lay directly onto the magnets and so you can resharpen very small pieces. The upper part of the chuck is made of BRASS, and that grants a longer life of the tool.
The magnetic chuck can be:
-
secured to any type of magnetic chuck ;
-
mechanically stirruped by means of the four holes around the edges, aligning or flanking a number of chucks.
The chuck is available in two sizes:
-
mm 200 x 70 x 20
-
mm 400 x 70 x 20
By aligning or flanking a number of magnetic chucks, extremely strong magnetic surfaces can be obtained. |
